Service Hotline
Slkormicro SLPESD0402M24: 24V Bidirectional 0.05pF DFN1006 High‑Speed Signal Line ESD Protection Device
1. Core Product Parameters
- Protection performance: Compliant with IEC 61000-4-2 standard, contact discharge 8kV, air discharge 15kV; typical trigger voltage 450V, typical clamping voltage 40V.
- Electrical parameters: Maximum continuous operating voltage 24V; maximum leakage current 10nA under 24V DC bias; typical capacitance 0.05pF measured at 10MHz.
- Temperature parameters: Operating temperature range -55℃~125℃; storage temperature range -40℃~85℃.
- Package and dimension: DFN1006 package, nominal component dimension 1.00mm×0.52mm×0.38mm; maximum outline dimension: length 1.10mm, width 0.62mm, height 0.45mm.
- Packing specification: 7-inch tape-and-reel package, delivery quantity 10000 pieces per reel.
2. Key Product Features
- Ultra-low parasitic capacitance with typical value of 0.05pF, bringing minor impact on signal integrity for high-speed and high-frequency transmission lines.
- Low leakage current with maximum value less than 10nA, generating negligible influence on DC bias of signal lines.
- Fast response with response time shorter than 1ns for rapid suppression of electrostatic surge.
- Bidirectional protection architecture, single component supports bidirectional ESD protection for one signal line.
- Complies with IEC 61000-4-2 ESD immunity standard, capable of 8kV contact discharge and 15kV air discharge ESD protection.
3. Main Application Fields
- High-speed interfaces including USB 3.0 and USB 3.1;
- Video interfaces including HDMI1.3, HDMI1.4 and HDMI2.0;
- Signal circuits for RF antennas;
- Data storage interfaces including SATA and eSATA.
4. Suggestions for Engineering Design
- This device is used for ESD protection of one bidirectional data line. One terminal connects to the protected signal line and the other terminal connects to system ground.
- Place the device as close as possible to the connector or signal input terminal.
- Minimize trace length between protection device and protected signal line to reduce parasitic inductance and ensure effective electrostatic discharge.
- Use complete ground plane whenever possible during PCB layout to optimize ground return loop.
- This component adopts DFN1006 package, use recommended pad dimension in datasheet for layout. Perform reflow soldering under lead-free condition: preheat temperature ranges from 150℃ to 200℃ with preheat duration of 60-180 seconds. Peak temperature shall not exceed 260℃. The dwelling time within 5℃ of peak temperature shall be no more than 30 seconds. The total time from 25℃ to peak temperature shall not exceed 8 minutes.
5. Product Summary
SLPESD0402M24 is a bidirectional ESD protection device in DFN1006 package. With typical low capacitance of 0.05pF, nanosecond-level fast response and low leakage current, it is well-suited for ESD protection of various high-speed signal interfaces. Its 24V continuous operating voltage together with 8kV contact discharge and 15kV air discharge rating defined by IEC 61000-4-2 standard protects high-speed signal links from electrostatic damage. Complying with layout, grounding and soldering requirements in practical PCB design enables the component to deliver full ESD protection performance and guarantee stable operation of high-speed interfaces.
About Slkor:
SLKOR's product portfolio includes discrete semiconductor devices such as diodes, transistors, and power devices, as well as integrated circuits such as linear regulators, DC-DC converters, interface chips, Hall sensors, ADCs, and battery management systems (BMS)
SLPESD0402M24To Product Page





粤公网安备44030002007346号